Quick Answer: How To Change Tire And Wheel Assembly Ona Troy Bilt Bronco Lawn Tractor?

How do you remove the wheels from a Troy Bilt Tiller?

Locate the roll pin securing the wheel hub to the axle. Place the tip of a 5/16-inch drift pin or a 16-penny nail over the top of the roll pin. Tap the end of the drift pin or nail with a hammer to drive the roll pin out of the wheel hub and axle. Pull the wheel off of the tiller axle.

How do you free a Troy Bilt tiller wheel?

If you look at the wheel where the axle passes through you’ll see the wheel has a pin that holds it on the axle, simply remove the pin and push the wheel in towards the case and insert the pin in the AXLE only, repeat for the other side and you’re in freewheel.

Can you use fix a flat on lawn mower tires?

Fix-a-Flat shouldn’t be used in tires on lawn mowers or tractors. What’s more, it could end up damaging the tire and putting the wheels out of balance. If you need your lawn mower tires fixed, it’s best to visit a tire repair expert to get your flat fixed.

How do you remove a stuck tiller wheel?

Tilt the tiller toward the opposite side of the tiller so the wheel you want to remove is off the ground and the axle has a slope. Shoot Liquid Wrench or some other good rust buster around the wheel while tapping the wheel with a hammer.

What kind of oil should I use in my Tiller?

Use SAE 5W-30 or SAE 10W30 in temperatures below 40 (F) degrees. Use SAE 30 when above 40 degrees (F).

How do you push a Troy Bilt Tiller?

Moving the Tiller

1. Place the Tines/PTO Clutch Lever in DISENGAGE position.
2. Move the Depth Regulator Lever down all the way into the. Travel setting.
3. If using engine power, move Wheel Speed Lever to either. SLOW or FAST, and use the Wheels/Tines/PTO Drive Lever. to drive the wheels.

How do you change the oil on a Troy Bilt Tiller?

Fill Tube System

1. Park the tiller someplace flat.
2. Remove any dirt, or oil buildup, around the oil fill tube with a paper towel.
3. Unscrew the cap on the oil fill tube.
4. Check the level of the oil inside the oil fill tube.
5. Park the tiller someplace flat.