Question: What Size Are The Freezes Plug In A 1945 2n Ford Tractor?

Are all freeze plugs the same size?

Freeze plugs come in many different sizes, and your engine will have multiple sizes, some engines have 10 or more plugs. You can purchase a complete freeze plug kit, or you can buy individual plugs if you need to only replace one or two. We highly recommend brass plugs for a lasting repair.

What is a 2N Ford tractor worth?

The 9N and 2N used three-speed transmissions, while the 8N was equipped with a four-speed, but this doesn’t seem to hamper the value of the older tractors. Prices typically range from $1,000 to $3,000, depending on condition.

What is the difference between a Ford 9N and 2N?

9N and 2N tractors had a 3-speed. The hydraulic 3-point arms have a halfway position between fully “up” and “down”. 9N and 2N tractors only had draft control. Both brake pedals are on the same side – 9N and 2N tractors were split.

How many freeze plugs does a Ford 302 have?

There are 11 all together, the ones on the front of the heads just pull the accessory drives off and they are right there. The ones on the bottum of the block are tricky.

What happens when a freeze plug pops out?

If the water in your engine block freezes, it will expand and push against the freeze plug. When it does, the plug will pop since it is the weakest element of the engine block. After that happens, the coolant/water will leak and trickle down the engine, further damaging the engine block.

Where are freeze plugs located?

Freeze plugs are usually aluminum or brass plugs pressed into holes in the water jacked of your engine block. In some cases, as the water freezes and expands in your block, the freeze plugs will push out relieving the pressure of the freezing water and partially draining your cooling system.

How do I know if my Ford tractor is a 2N?

The best way to identify a tractor is by the serial number. Serial numbers on the 9N- 2N and 8N tractors are located on the left side of the engine block, just below the head and behind the oil filter. The numbers are usually not stamped very deep (or very straight).

How much horsepower does a 2N Ford tractor have?

Ford 2N

Ford 2N Power:
Drawbar (claimed):	12 hp [8.9 kW]
PTO (claimed):	23 hp [17.2 kW]
Mechanical:
Chassis:	4×2 2WD

21

What is a 1948 Ford 8N tractor worth?

I my area, a decent 8N would go for between $2500 and $3,000.

Is a Ford 9N a good tractor?

The short answer is yes. The 9N is one awful tractor to work compared to an 8N, NAA or later. Not only do you don’t get position control and live hydraulics like on the 8N, both the clutch and left wheel brake are on the left, meaning with the clutch depressed you can only use the right brake.

Which is better 8N or 9N?

They really are basically the same. Only major differences are a couple horsepower, 8n has 4 speed trans and 9n has 3 speed trans. 8n is newer than the 9n and has more hp. Newer 8n have side distributor older 8n’s and 9n’s had front distributor.

What year did Ford stop making tractors?

Henry Ford and Harry Ferguson.In 1928, Fordson tractor production was halted in the United States, only to be resurrected in 1939 as the Ford Model 9N.

How do you replace a soft plug?

How to Replace Freeze Plugs in Engines

1. Drain the antifreeze from your car so it doesn’t spill on the ground when you remove the freeze plug.
2. Remove the parts blocking your way to the freeze plugs.
3. Break the freeze plug free.
4. Remove the freeze plug.
5. Clean the hole that the freeze plug came out of.
6. Place the new freeze plug in the hole.