Question: How To Replace The Drive Belt On A Craftsman Yts 4500 Tractor?

How do you tighten the drive belt on a Craftsman riding lawn mower?

Push the belt keepers on the transaxle pulley down and slide the belt over the transaxle pulley. Pull the slack from the back of the tractor (transaxle pulley) and slide the belt on to the stationary and clutch idlers. This will increase the tension in the belt and hold it in place.

How long is the drive belt on a Craftsman riding mower?

Drive Belt Craftsman mowers have primary and secondary drive belts. Both belts range between 42 to 50 inches long, depending on the mower’s model.

What is a ground drive belt?

The ground drive belt connects the engine crankshaft to the transaxle pulley to drive the rear wheels. If the belt breaks, the lawn tractor won’t move. If the belt is worn, the lawn tractor moves sluggishly because the belt slips on the pulley.

How do you tighten a drive belt on a countax?

To correct the tension, follow this procedure:

1. Release the tension on the belt by pulling the Belt.
2. Taking care not to burn yourself on a hot exhaust, locate.
3. Remove the Spring Clip and washer holding the.
4. Both the Trunnion and the Belt Tension Rod are.
5. Having made the adjustment, re-locate and secure the.

Why does my drive belt keep coming off my riding mower?

The drive belt may come off a riding mower because it is damaged or loose. When loose, the belt may slip, resulting in friction that, if it creates enough heat, can lead to a fire in the mower’s engine.

What size drive belt does a craftsman lt1000 take?

95.5″ is the correct size.

What size belt goes on a Craftsman 42 inch deck?

174883. AYP / Craftsman / Sears Deck Drive Belt fits 42 ” cut (2002-2003). Size: 5/8″ x 97″. Replaces part number 174883.

How do you adjust the drive belt on a riding lawn mower?

How to Tighten a Riding Lawnmower Belt

1. Turn off the engine of your lawnmower and disconnect the spark plug wire as well.
2. Locate the main frame tube on your lawnmower.
3. Locate the belt, also known as the drive belt, inside the deck of your lawnmower.
4. Tighten the belt of your lawnmower by shortening the location of the main frame inside the clamps.

Can you stretch a lawn mower belt?

Yes, lawnmower belts can stretch. Continuous wear due to regular operation can cause them to elongate over time. When it stretches more than it should, it can result in the drive belts lose grip on the pulley system.

How do I know if my lawn mower belt is bad?

These signs show when a mower belt could experience failure and needs replacement as soon as possible:

1. The belt has s​​​ide wall damage. Mower belt edges should be smooth and even throughout the entire length of the belt.
2. The belt has a glazed or bu​rned sidewall.
3. The belt is​​ cracked.

Who makes Craftsman ride on mowers?

All Craftsman mowers are made by MTD. Craftsman lawn tractors run the price spectrum from rear-drive models priced around $1,300 to fully featured, hydrostatic-drive units that cost more than $2,000. Most Craftsman lawn tractors feature Briggs & Stratton engines, and the 42-inch-deck models are among the most popular.