Often asked: Why Go 15″ Or 16″ Front Tractor Tire?

What is the purpose of dual tires on a tractor?

They are called duals (as in dual tires ). There are two reasons for duals: The help get all the power of the engine (expressed as torque) to the ground by providing more surface area and lugs in the tires on the ground reducing slip). Basically provide better traction.

How much air should be in a front tractor tire?

General ballast recommendations are: 2WD 25% front /75% rear, MFWH 35% front /65% rear, and 4WD 55% front / 45% rear. Once ballasting is correct, the tire can pressure can be checked and set. Correct tire pressure for the load and speed will be manufacturer specific with each publishing charts with their recommendations.

How do tractor tire sizes work?

Three-number Tire Sizing The three-number lawn tractor tires numbering system works a bit differently. 15×6.00-6 is a common size. The first number before the “x” indicates the tire’s diameter when inflated and not under load. The middle number between the “x” and the “-,” indicates the tire’s width.

Which way should tractor tire tread face?

For best traction, the tread should be pointed in the direction of travel (looking at the top of the tire ).

How wide is a tractor with duals?

Width: 10 feet. Height: 11 feet 3 inches.

Is 35 psi too high?

Higher pressure generally is not dangerous, as long as you stay well below the “maximum inflation pressure.” That number is listed on each sidewall, and is much higher than your “recommended tire pressure ” of 33 psi, Gary. So, in your case, I’d recommend that you put 35 or 36 psi in the tires and just leave it there.

What pressure should my tractor Tyres be?

Tyre selection should be based on the axle loads being carried and the level of ground pressure required. Ground pressures required will depend on the work being done and soil conditions. For cultivations and drilling work, tyres large enough to operate at pressure of 0.8 bar (12 psi ) and below are now frequently used.

How tall is a 9.5 16 tractor tire?

Additional information

Weight	55 lbs
Size	9.5-16, 9.5×16
Rim Diameter	16
Width	9.5, 9.50, 950
Height /Ratio	33

2

Can I put bigger tires on my riding mower?

Bigger tire will have more traction. Try for a 17×7. 50 if it fits that will get better traction and be a little faster, but not enough to affect torque a lot.

Which TYRE is best for tractor?

Top 7 Tractor Tyres Brands in India

• Apollo Tyres. Apollo Tyres Ltd.
• BKT Tyres. Balkrishna Industries Limited (BKT) is a Tyre manufacturing company based in Mumbai, India and founded in 1987.
• Good Year Tyres.
• CEAT Tyres.
• MRF Tyres.
• Birla Tyres.
• JK Tyres.

What are standard tire sizes?

Common Tire Sizes

• 14 Inch Tires. Expandable Link. Passenger Car and Light Truck/CUV/SUV Tire Sizes.
• 15 Inch Tires. Expandable Link.
• 16 Inch Tires. Expandable Link.
• 17 Inch Tires. Expandable Link.
• 18 Inch Tires. Expandable Link.
• 19 Inch Tires. Expandable Link.
• 20 Inch Tires. Expandable Link.
• 21 Inch Tires. Expandable Link.

Why are front grader tires backwards?

On the drive tires the tires are pulling on the ground to move the machine forward. On the front the ground is pushing back on the tires to make them roll so they are turned backwards to get the same cleaning effect as the rears. Without it they would just ball up and slide.

What is the difference between R1 and R4 tractor tires?

These tires offer excellent traction on harder surfaces such as construction lots and are less aggressive on turf than an R1 tire. An R4 tire is more aggressive than an R3 tire, however, it is less aggressive than an R1 tire. An R4 tread depth is about 70 percent as deep as an R1 tire.

What are R4 tractor tires used for?

R4 tires are most commonly used in roadwork or hard ground applications. They have a tread depth that’s about halfway between the depth on R1 and R3 tires.