Often asked: How To Adjust Your Deck On Your Toro Ss 4560 Tractor?

How do you adjust a Toro Timecutter mower deck?

see an uneven cut on your lawn.

1. Park the machine on a level surface and disengage the. blade control switch.
2. Move the motion control levers outward to the park.
3. Check the air pressure of all four tires.
4. Set the height-of-cut lever to the 3 inch (76 mm)
5. Carefully rotate the blade(s) side to side (Figure 56).

How do you adjust the deck on a Toro grandstand?

Leveling the Mower Deck

1. Position mower on a flat surface.
2. Disengage the PTO, move the motion-control levers to.
3. Stop the engine, remove the key, and wait for all moving.
4. Check the tire pressure of both drive tires; refer to.
5. Lower the mower to the 76 mm (3 inch) height-of-cut.
6. Check the distance between the swivels, measure at the.

How do you adjust a Toro deck?

Turn the mowing deck adjustment gear clockwise with the wrench to raise the mowing deck or counterclockwise to lower the deck. Check the left and right cutting blade tip distances to the ground, and rotate the adjustment gear until the left and right cutting blade tip distances to the ground are the same.

Should a mower deck be level?

For most effective results, a lawn mower deck should have a pitch of 1/8-inch to 1/2-inch between the height of the deck rear to the height of the deck front. In any case, the front of the deck needs to be pitched lower than the deck rear, but don’t pitch too much because deck pitch that’s too steep can scalp lawns.

Should a ride on mower deck be level?

Level the mower deck to ensure grass cutting height is even across the width of the deck. This will help ensure a smooth and seamless side-by-side blend between each row of freshly cut grass.

Why does my mower cut uneven?

Uneven cutting is wavy or smooth troughs in the lawn surface. Uneven cutting is usually caused by mower deck damage or misadjustment.

Why is my mower deck lower on one side?

If the deck on your lawn tractor is lower on one side than the other, the result is an uneven cut. Leveling your tractor’s deck periodically smooths out your lawn.

How do you adjust the height of a deck on a Simplicity mower?

To raise the front of the mower deck, loosen the front nut and turn the rear nut against the bracket. To lower the front of the mower deck, loosen the rear nut and the bracket will move backwards to lengthen the rod.

Why is my mower cutting lower on one side?

Step cutting is usually caused by mower deck damage, misadjustment, or mower blade damage. Normally the deck just needs to be re-leveled. The next thing to do is to turn the blades and measure again. If the measurements are not the same, one of the blades is probably bent.

How do I lower the Toro mower deck?

Move the cutting height lever on one of the front wheels forward to lower the cutting height at that wheel or backward to raise it. You may have to push or pull the lever slightly in order to slide it into the desired position.