FAQ: Where To Fill The Motor Oil On My Farmall Super A Tractor?

How many quarts of oil does a Farmall Super A hold?

Farmall Super A Engine

Engine Oil
Oil capacity: 5 qts 4.7 L
Oil change: 120 h

1

What is the difference between a Farmall A and Super A?

The noticeable difference between the Super A and A-1 is the distance between the fuel tank and the hydrualic reservoir the Super A has about a 3/4″ space between the two, while the A-1 has about a 2″ space.

What kind of oil does a Farmall H take?

Engine; 10w-30 or 30w. Some will tell you to use non detergent oil, but I have used 10w-30 Mobil in my M for almost 15 years with no problems.

What type of oil does a Farmall 140 take?

Manual says use IH HY-Tran Fluid, that meets IH Spec.

How much oil does a super a take?

Farmall Super M – engine

Engine Detail: International Harvester C264 gasoline 4-cylinder liquid-cooled vertical I-head 264 ci [4.3 L]
Bore/Stroke: 4.00×5.25 inches [102 x 133 mm]
Oil capacity: 8 qts [7.6 L]
Coolant capacity: 26 qts [24.6 L]
Sparkplug gap: 0.023 inches [0.584 mm]
You might be interested:  Quick Answer: What Is The Ohm Range On A Massey Furgeson Tractor Fuel Gauge?

29

How many horsepower is a Farmall Super A?

Farmall Super A

Farmall Super A Power
Drawbar (claimed): 13 hp 9.7 kW
PTO (claimed): 16 hp 11.9 kW

What years were Farmall A made?

The Farmall A was built by International Harvester from 1939 to 1947 in Chicago, Illinois, USA and Louisville, Kentucky, USA.

How much is a Farmall Super A worth?

The restored 1949 Farmall Super A pictured here, with turf tires and a belly-mounted Woods mower, sold for a healthy $14,500, burying RM’s $7,500-$10,000 pre-auction estimate, and surprising us as well.

How many Farmall Super A’s were made?

Farmall Super A-1

Model history
Model introduced 1954
Model discontinued 1954
Model status Discontinued Discontinued
No. produced 1,502

34

How do you tell what year a Farmall tractor is?

To determine the year, look at the last letter in the series. Add the number of that letter’s place in the alphabet (A = 1, B = 2, C = 3, and so on) to 1930 to determine the year.

How much hydraulic oil does a Farmall M hold?

Yes, 6 quarts.

How do you check hydraulic fluid on a Farmall 140?

To check the hydraulic fluid go to the left side (from driver’s seat) of the tractor. Look for the bracket that holds up the rear of the gas tank. Follow down to the side of the tractor from that point and look for a flat headed bolt. Take the bolt out.

Leave a Reply

Your email address will not be published. Required fields are marked *

Adblock
detector